气相输运沉积制备c轴择优取向的碘化铋薄膜

铋基卤化物材料因其无毒和优良的光电性能而显示出巨大的应用潜力。BiI₃作为一种层状重金属半导体,已被用于X射线检测、γ射线检测和压力传感器等领域,最近其作为一种薄膜太阳能电池吸收材料备受关注。本文采用简单的气相输运沉积(VTD)法,以BiI₃晶体粉末作为蒸发源,在玻璃基底上得到高质量c轴择优取向的BiI₃薄膜。并通过研究蒸发源温度和沉积距离对薄膜物相和形貌的影响,分析了BiI₃薄膜择优生长的机理。结果表明VTD法制备的BiI₃薄膜属于三斜晶系,其光学带隙为~1.8 eV。沉积温度对薄膜的择优取向有较大影响,在沉积温度低于270 ℃时,沉积的薄膜具有沿c轴择优取向生长的特点,超过此温度,c轴择优取向生长消失。在衬底温度为250 ℃、沉积距离为15 cm时制备的薄膜结晶性能最好,晶体形貌为片状八面体。     

Two-dimensional topological semimetals

The field of two-dimensional topological semimetals, which emerged at the intersection of two-dimensional materials and topological materials, has been rapidly developing in recent years. In this article, we briefly review the progress in this field. Our focus is on the basic concepts and notions, in order to convey a coherent overview of the field. Some material examples are discussed to illustrate the concepts. We discuss the outstanding problems in the field that need to be addressed in future research.     

A self-powered and sensitive terahertz photodetection based on PdSe2

With the rapid development of terahertz technology, terahertz detectors are expected to play a key role in diverse areas such as homeland security and imaging, materials diagnostics, biology, medical sciences, and communication. Whereas self-powered, rapid response, and room temperature terahertz photodetectors are confronted with huge challenges. Here, we report a novel rapid response and self-powered terahertz photothermoelectronic (PTE) photodetector based on a low-dimensional material: palladium selenide (PdSe₂). An order of magnitude performance enhancement was observed in photodetection based on PdSe₂/graphene heterojunction that resulted from the integration of graphene and enhanced the Seebeck effect. Under 0.1-THz and 0.3-THz irradiations, the device displays a stable and repeatable photoresponse at room temperature without bias. Furthermore, rapid rise (5.0 μs) and decay (5.4 μs) times are recorded under 0.1-THz irradiation. Our results demonstrate the promising prospect of the detector based on PdSe₂ in terms of air-stable, suitable sensitivity and speed, which may have great application in terahertz detection.     

Coupling characteristics of laterally coupled gratings with slots

Laterally-coupled ridge-waveguide distributed feedback lasers fabricated without epitaxial regrowth steps have the advantages of process simplification and low cost. We present a laterally coupled grating with slots. The slots etched between the ridge and grating area are designed to suppress the lateral diffusion of carriers and to reduce the influence of the aspect-ratio-dependent-etching effect on the grating morphology in the etching process. Moreover, the grating height in this structure can be decreased to lower the aspect ratio significantly, which is advantageous over the conventional laterally coupled ridge waveguide gratings. The effects of five main structural parameters on the coupling characteristics of gratings are studied by MODE Solutions. It is found that varying the lateral width of the grating can be used as an effective way to tune the coupling strength; narrow slots (100 nm and 300 nm) and wide ridge (2 μm-4 μm) promote the stability of grating coupling coefficient and device performance. It is important to note that the grating bottom should be fabricated precisely. The comparative study of carrier distribution and mode field distribution shows that the introduction of narrow slots can strengthen the competitive advantage and stability of the fundamental mode.     

The study of wave motion in the Talbot interferometer with a lens

We present the study of the wave motion in the Talbot interferometer with an additional element such as a lens for all related audiences. Our solutions are in the analytic form. A general principle of the Talbot effect, which is the optical near-field effect, is the Fresnel diffraction. The Fresnel integral is rather complicated. We therefore introduce an alternative method which is based on the wave propagation through the transmission functions of the grating and the lens. Our method has been proved by a simple experimental setup.     

钴掺杂MoSe2共生长中氢气的作用分析及磁电特性研究

采用原位共生长化学气相沉积法,以Co3O4、MoO3、Se粉末为前驱物,710℃下在SiO2衬底上生长掺钴MoSe2纳米薄片,分析讨论氢气含量对其生长及调节机理的影响.表面形貌分析表明,氢气的引入促进了成核所需的氧硒金属化合物以及横向生长中需要的CoMoSe化合物分子的生成;AFM(Atomic Force Microscope)结果表明氢气有利于生长单层二维超薄掺钴MoSe2.随着Co3O4前驱物用量的增加,样品的拉曼和PL(Photoluminescence)谱图分别表现出红移和蓝移现象,带隙实现从1.52—1.57 eV的调制.XPS(X-ray photoelectron spectroscopy)结果分析得到Co的元素组分比为4.4%.通过SQUID-VSM(Superconducting QUantum Interference Device)和器件电学测试分析了样品的磁电特性,结果表明Co掺入后MoSe2由抗磁性变为软磁性;背栅FETs器件的阈值电压比纯MoSe2向正向偏移5 V且关态电流更低;为超薄二维材料磁电特性研究及应用拓展提供了基础探索.     

二维CdO的低晶格热导率研究

寻求具有较小晶格热导率k_lat的高热电性能的二维材料具有重要意义。基于从头计算和声子玻耳兹曼输运理论,该研究首先对二维CdO结构进行优化,并通过计算声子谱验证了单层CdO的动力学稳定性。在此基础上详细研究了单层CdO的声子输运性质。计算表明在室温下单层CdO的晶格热导率k_lat约为5.7 W/(m·K),低于单层石墨烯、磷烯、黑磷和MoS₂等二维材料的晶格热导率。其中,Z方向声学模式(Z-direction acoustic, ZA),横声学支(transverse acoustic,TA),纵声学支(longitudinal acoustic, LA),Z方向光学模式(Z-direction optical, ZO),横光学支(transverse optical, TO),纵光学支(longitudinal optical, LO)对k_lat的百分比贡献分别为73.7％、13.9％、3.7％、2.8％、4.7％和1.2％。研究发现,ZA、TA、LA声学支和光学支之间的强散射是导致单层CdO低热导率的原因。本文计算结果可用于指导基于CdO的低维热电器件的设计。     

金属Al背电极二维AZO光栅的制备和陷光特性

研究了背电极金属Al膜上二维ZnO:Al光栅的制备及其反射光谱特性.在厚度为300 nm的Al膜上溅射80 nm ZnO:Al薄膜,旋涂AZ5206光刻胶,用波长为325 nm的激光进行光刻制作光栅掩模.采用溶脱-剥离法在Al衬底上制备周期(624~1250 nm)和槽深(100~300 nm)可独立调控的ZnO:Al二维光栅.表面形貌采用原子力显微镜和扫描电镜观察,反射光谱用带积分球的分光光度计测试,双向反射分布函数用散射仪测量.结果表明,300 nm Al膜上织构二维ZnO:Al光栅背电极结构,当光栅槽深为228 nm,周期从624 nm增加到986 nm时,背电极总反射率、漫反射率以及雾度均随光栅周期增大而显著增加,而当周期从986 nm增加到1250 nm时,总反射率、漫反射率以及雾度略有增加.双向反射分布函数测试结果进一步证实了上述实验结果,即随着周期增大,漫反射峰值越大,衍射峰个数也增多.提示背反电极上槽深为228 nm、周期为986 nm的二维ZnO:Al光栅具有较好的散射效果,其中漫反射占总反射的百分比为45%.     

某型机进近段高精度相对姿态实时测量技术

某型机在飞行训练过程中，进近段的二维相对姿态数据对于该型机安全着陆有着至关重要的作用。基于无线网络电台的双向数据传输系统能够实时获取进近段飞机相对理想着陆点的水平、垂直相对位置数据。通过上行链路上传着陆点的姿态数据，下行链路实时下传动动差分后的差分数据,最后在中心控制站进行二次数据处理。该技术获得的进近段二维相对姿态精度达到厘米级，满足飞行训练的需求。同时结合飞机显控数据以及视景图，以多角化动态关联的方式将实时获取的姿态数据等呈现给指挥员，更好地辅助指挥员进行着陆指挥工作。